Gap Diagnostic IIDTool - Sub-Function Definitions; Limits

To Next Page

To Previous Page

94 95

IIDTool

User Manual : Version 33, Firmware V3.0

4.4.2 Sub-function denitions

Sub-function A󰀨ected axle Availability

Adjust All Front and Rear All*

Adjust Front Front Only All*

Adjust Rear Rear Only All*

Adjust Access Front and Rear L322-02

AdjustO󰀨-Road Front and Rear independently L322-02

Adjust Motorway Front and Rear L322-02

Table 25. Heightsub-functiondenitions

For these vehicles, normal or standard height is adjusted. As the normal height is the reference, access

ando󰀨-roadheightswillalsobea󰀨ected.

Note : If two subsequent modications of -10 mm are performed, the vehicle will be 20 mm lower than

the initial height.

4.4.3 Limits

TheEASECUacceptsadenedrangeofvaluesthatlimittheamountofchangepossible.Theselimits

are related to sensor calibration.

Note : Each sensor calibration (section 4.6.7) represents electrical arbitrary values associated with

height sensors. They take into account the mechanical mounting position of each sensor and should

only be changed in case of sensor replacement or removal.

The limits are :

Value (mm)

Limit L322-02 L322-06 All others

Upper Front 200 205 250

Upper Rear 200 250 250

Lower No Limit 150 150

Table 26. EAS Internal limits

Example, if the calibrations are as following (L322-02)

Sensor Calibration example, L322-02

Front Left 157

Front Right 138

Rear Left 180

Rear Right 166

Table 27. Example of current calibrations

Other manuals for Gap Diagnostic IIDTool