Gap Diagnostic IIDTool - Page 172

172
IIDTool
GAP Diagnostic 2019-07-15 All Rights Reserved
User Manual : Version 33, Firmware V3.0
Recovery method
II If the instrument pack software update fails and usage of the integrated interface is required (not
using a mobile device or the PC-based interface), the IIDTool will no longer be able to write on the ins-
trument cluster screen. Also, the engine won’t start. The following steps will allow retrying the software
update without having access to the IIDTool’s menu.
• DisconnectyourIIDToolandturnthekeytotheOFFposition.
• TurnthekeytotheONpositionandconnectyourIIDTool.
• WaituntiltheIIDToolLEDturnsandstaysON.
• Pressthedown/lowerbuttonofthesuspensionheightselectoronthecentreconsole.Holdthe
button until the LED turns OFF (approximately 12 seconds).
• Afterafewseconds,thesoftwareupdatewillbeginandtheLEDwillstartashing.Theprocess
takesaroundoneminute.Whennished,theInstrumentPackwillturnON.
• OncetheinstrumentpackturnsON,waitafewsecondsandcyclethekeyfromtheOFFtothe
ON position.
App Simplyrepeatthereashingsteps.
You can now use your IIDTool and vehicle normally.
If the recovery method was not successful, please contact the manufacturer for additional support :
support@GAP-Diagnostic.com.