AT600 User’s Manual 105
Chapter 5. Communication
Command 173 (0xAD): Set Loop Current Error Handling (cont.)
Table 64: Response Data Bytes for Set Loop Current Error Handling
Byte Format Description
0 Unsigned-8 Analog Output Error Handling:
0: Low;
1: High;
2: Hold;
3: Other value;
1 - 4 Float Error Value, unit is mA
Table 65: Command-Specific Response Codes for Set Loop Current Error Handling
Code Class Description
0 Success No Command-Specific Errors
1-4 Undefined
5 Error Too Few Data Bytes Received
6 Error Device-Specific Command Error
7Error In Write Protect Mode
8-15 Undefined
16 Error Access Restricted
17-127 Undefined
To Next Page
