AT600 User’s Manual 125
Chapter 5. Communication
Command 202 (0xCA): Write Pipe Lining Attribute (cont.)
Command 203 (0xCB): Write Sensor Meter Setup
This command is to write sensor meter setup.
Table 122: Command-Specific Response Codes for Write Pipe Lining Attribute
Code Class Description
0 Success No Command-Specific Errors
1-4 Undefined
5 Error Too Few Data Bytes Received
6 Error Device-Specific Command Error
7Error In Write Protect Mode
8-15 Undefined
16 Error Access Restricted
17-127 Undefined
Table 123: Request Data Bytes for Write Sensor Meter Setup
Byte Format Description
0 - 3 Float Zero Cutoff
Table 124: Response Data Bytes
Byte Format Description
0 - 3 Float Zero Cutoff
Table 125:
Command-Specific Response Codes for Write Sensor Meter Setup
Code Class Description
0 Success No Command-Specific Errors
1-4 Undefined
5 Error Too Few Data Bytes Received
6 Error Device-Specific Command Error
7Error In Write Protect Mode
8-15 Undefined
16 Error Access Restricted
17-127 Undefined
To Next Page
Loading...
