GE AT600 - Page 138

Chapter 5. Communication
126 AT600 User’s Manual
Command 204 (0xCC): Write Transducer Information
This command is to write transducer information
.
Table 126: Request Data Bytes for Write Transducer Information
Byte Format Description
0 - 3 Unsigned-32 Transducer type:
0: Other;
10: CPT-0.5
11: CPT-2.0
12: CPT-0.5-MT C-PB-05-M
13: CPT-1.0-MT C-PB-10-M
14: CPT-2.0-MT C-PB-20-M
15: CPT-0.5-HT
16: CPT-1.0-HT
17: CPT-2.0-HT
18: CPS-0.5
19: CPSM-2.0
20: CTS-1.0
21: CTS-1.0-HT
22: CTS-2.0
23: C-LP-40-HM
24: C-LP-40-NM
25: CPB-0.5-HT
26: CPB-2.0-MT
27: CPB-0.5-MT
28: CPB-2.0
29: CPB-0.5
30: CPS-1.0 CPT-1.0
31: CWL-2
32: CPS-1.0
33: CPW (WT-1P-1.0 on AB82
34: CPW (WT-1P-0.5 on NDT plastic
35: CPW (WT-1P-1.0 on NDT plastic
36: CPB-1.0-HT
37: CPB-2.0-HT
38: CPB-1.0
39: CPB-1.0-MT