NetworX Version 3 Installation Manual
16
Parts of the system
Table 5. System modules
Part number Description Purpose
NX-1048-R-W
Wireless Menu
LCD Keypad
Used for programming and using the system. Wireless and
wired keypads can be used.
NX-1048-W
Menu LCD Keypad
(wired)
NX-1701E
Door swipe
module
Proximity card reader/door control module. You can program it
to control access in any or all partitions.
NX-320-I
Auxiliary power
module
Provides additional power for modules attached to a panel.
NX-507E/NX-
508E
Output expander
module
Expands the number of outputs available on the system.
NX-534E
Audio (listen-in)
module
Two-way audio (listen-in) communicator that allows the
situation on the premises to be monitored.
NX-535 Voice module Allows events to be reported using voice messages.
NX-586E
Direct connect
module
Used as:
1. A direct connect interface between the panel and PC.
2. A storage device, when connected only to the PC. You can
also read/write from 1 of the 4 locations via the DL900
downloader.
3. A storage device, connected only to the panel. You can
read/write from 1 of the 4 locations on the NetworX V3.
NX-590E TCP/IP Module Dual microprocessor-controlled Internet/Intranet interface.
To Next Page
Loading...
