NetworX Version 3 Installation Manual
192
options. To verify enrolling, check that the event log contains an enrol event for the GSM/GPRS
module.
1. Press OK at the system prompt and enter your installer code.
2. Navigate with the ½¾ keys to Enrol Modules>Enrol and press OK.
3. The keypad starts enrolling the modules. The Enrolling Modules message is displayed
while enrolment is taking place (approximately 12 seconds).
4. When the modules have been enrolled, a beep sounds and the message disappears.
5. To verify the enrolled modules, navigate with the ½¾ keys to Maintenance Mode and
press OK.
6. Scroll to Log Review and press OK. When the control panel enrols a module, it adds an
enrol event to the event log. This event contains the module number. Scroll through the
event log to verify that the GSM/GPRS module has been enrolled (module ID 78).
Note: Each time you exit programming mode, the modem resets and restarts and reads the PIN number, network
operator, SMS center number and any other information, from the configuration.
Enrolling the SIM card on the GSM network
1. Enter programming mode.
2. Select NX-7002 Module>Options>GSM>SIM PIN Code and press OK.
3. Enter the SIM PIN and press OK.
4. Exit programming mode. The SIM PIN is automatically enrolled on the GSM network.
Enrolling the SIM card on the GPRS network
1. Enter programming mode.
2. Select NX-7002 Module>Options>GSM>SIM PIN Code and press OK.
3. Enter the SIM PIN and press OK.
4. Obtain an Access Point Number from the supplier. Select NX-7002
Module>Options>Network>GPRS APN and enter it.
5. You may need to enter the PPP password and PPP user ID required by the network. To do
this select NX-7002 Module>Options>Network>User ID and NX-7002
Module>Options>Network>Password. This step is not usually required.
6. Exit programming mode. The SIM PIN is automatically enrolled on the GSM network
To Next Page
Loading...
Need help?
General
