NetworX Version 3 Installation Manual
33
9. The keypad communicates with the panel and sends data entered in steps 3 to 8. The
Learn-in Mode message displays briefly.
10. The keypad is learned-in and displays the System Ready message.
Important: You should not program zero-only strings (for example, "000") as values for SysID, KID1, KID2 nor
Encryption Key, as it will make the keypad non-operational.
Note: If the learned-in keypad's configuration stored in the RF receiver, differs from the actual keypad's configuration,
the RF receiver will start the configuration copying process. It takes a couple of seconds, and during this
process the keypad displays the "Copying" message. During this operation, due to an intensive radio
communication, you should not perform any additional actions on other wireless keypads.
Installing the wireless sirens
In order to guarantee communication between the panel and the siren, each siren must be learned-in.
This procedure requires starting the learn-in mode in the control panel with the menu, and then
tripping the tamper switch of the siren. For all steps required to program a new siren, see
Learning-in
wireless sirens on page
176.
To install the wireless siren:
1. Select the appropriate location to install the siren, and mount the siren base to the wall.
2. Insert the batteries to power the siren. In case of the indoor siren, the battery holders for
four (4) AA 1.5 V batteries and one (1) 9 V battery are located inside the housing of the
siren. In case of the outdoor siren, you should install the battery pack inside the housing
of the siren. The battery pack contains independent batteries for the speaker and the
beacon.
3. Wire the battery pack to the siren's terminals.
4. Learn-in the siren (see Learning-in wireless sirens on page 176).
5. When installing the outdoor siren, before final commission cut jumper J3 on the siren
PCB. This jumper is used as start-up protection.
6. Close the cover plate on the siren.
CAUTION: When replacing siren's batteries follow instructions in the siren's manual delivered with your device.
Batteries can explode or cause burns when recharged, incorrectly (dis)assembled, or exposed to fire or
high temperatures. Dispose of used battery according to battery directive instructions and/or as
required by local laws. Keep away from children. Always use batteries that are from the same batch,
and alwa
To Next Page
Loading...
Need help?
General
