NetworX Version 3 Installation Manual
273
Permission for the installer
The installer can access the sytem only with the user’s permission (even if the installer has the
authority to arm/disarm the partition). Before the installer is able to enter the installer code, the user
must cancel the active screen saver by entering the user code.
Changing user codes and/or rights
The installer is not allowed to change any user information. The appropriate menu is available for the
Master User (adding new users, deleting users, changing user names and authorities) or the regular
user (changing the user’s own code and name).
Note: The Master User is not allowed to edit/change other users codes. The only person allowed to change the user
code is the user the particular code belongs to.
Any changes to the user code or user authorities are logged. Two events - User Code Changed and
User Option Changed - are logged in each case respectively.
Keypad
The keypad in a EN 50131-compliant system must have an additional screw keeping the cover in
place.
Screen saver
In the EN 50131 Mode, the screen saver functionality is always active. The screen saver turns on
after 30 seconds of the user’s inactivity. You can also turn it on manually by pressing both arrow
keys on the keypad simultaneously. To cancel the screen saver you have to enter the user code.
Note: The screen saver also turns on immediately after the Exit Delay expiration, even if it is shorter than 30 seconds.
Note: If Screensaver is active, also chime and function keys are disabled.
To Next Page
Loading...
Need help?
General
