GE NetworX V3 - Chapter A4 Programming Guidelines; Getting Started; Country Codes

NetworX Version 3 Installation Manual
39
Chapter A4 Programming guidelines
Getting started
This chapter describes a NetworX V3 installation with the menu driven keypad allowing you to
program the system easily using a menu structure.
Country codes
The NetworX V3 has the ability to set different “country codes”. Each country code has specific
default settings. When you start your system for the first time (see Powering up the system below)
and select keypad defaults during the initial keypad setup, the respective country code is also set up
automatically for the panel. Once the country code has been selected, it will remain set, even after an
installer reset. When changing the country code during programming, all existing programming will
be cleared to the defaults for that country
.
Note: For a detailed first keypad installation description, see Wireless keypad learning-in procedure on page 32.
The table below lists the default country codes.
Table 9. Country codes
Code Country
0 No country (factory setting)
1 Holland
2 Belgium / Poland
3 Sweden
4 Italy
5 Spain
6 Greece
7 South Africa
8 Israel
9 Spain (PRSGR)
10 Turkey
11 France
17 Turkey Pronet
50 US
For all the countries there are the following default codes:
Table 10. Default codes
User code Installer code Download access code
1234 9713 84800000