GE NetworX V3 - Connecting the NX-586 E to a Panel; Programming the NX-586 E Direct Connect Module

NetworX Version 3 Installation Manual
245
Figure 30. Connecting the NX-586E to a PC and a panel
Connecting the NX-586E to a panel
Connect the cable with alligator clips to a NetworX V3 panel as follows:
• Red to POS
• Black to COM
• Green to DATA
Programming the NX-586E direct connect module
Figure 31. NX-586E menu structure
The control panel’s programming memory can be copied to one of the four programming memories
in the NX-586E direct connect module and vice-versa. You must enrol and default the module before
you begin to program the system. For more information on enrolling and defaulting, see
Chapter B7
Enrolling modules.
NX-586
DATA
POS
COM
#
"
!
NX-10
Files
File 1 Panel Type
Panel to File
File to Panel
Options
Speed
13.1
13.2
13.1.
13.2.1
13.1.1.
13.1.1.2
13.1.1.3
Files 2 - 4
Same as above