NetworX Version 3 Installation Manual
264
Appendix 4: Service messages
The keypad displays service messages as a result of manual and automatic tests. Table 48 Service
messages lists each message and outlines the action you should take to resolve the problem. When
the keypad beeps due to a fault condition, press the # key to view the fault condition information.
After pressing the # key faults are displayed in the particular order. The order is as following:
1. Panel overcurrent
2. Siren trouble
3. Box tamper
4. Fail to communicate
5. Line fault
6. Loss of time
7. Mains fault
8. Low battery
9. Remote over current
10. Remote fail to communicate
11. Remote low battery
12. Remote box tamper
13. Expansion trouble
14. Remote siren fault
15. RF jam
16. Zone problem
17. Bus fault
Table 48. Service messages
Message Definition Action
Panel
Box Tamper
There has been interference with the
control panel casing.
Ensure that the casing is mounted correctly on a
flat surface and is not damaged. If there is no
damage, close the casing securely.
Panel
Fail to
Communicate
The control panel tried to send a
message to the central station but
failed.
Ensure that the phone line is connected properly.
Use a test phone to check that the phone service
is available. Ensure that the central station phone
number, account and protocol options are
correct.
Panel
Loss of Time
The control panel has had a total loss of
power and the clock must be reset.
Reset the system clock and date using the User
Menu>Set Date/Time menu option..
To Next Page
Loading...
Need help?
General
