NetworX Version 3 Installation Manual
238
Table 36. Event description
Event description Explanation
L1 Event Type PN Partition Name
L2 HH:MM DD/MM UN/ZN Zone/User Name LOG
Event Type The type of event that occurred.
PN The number of the partition in which the event occurred.
Partition Name The name of the partition in which the event occurred.
Zone/User Name The zone name or user name.
UN/ZN The user number, zone number or device number.
HH:MM The hour and the minute the event occurred.
DD/MM The day and month the event occurred.
LOG The position of the event in the event log.
Event log events
Table 37. Event list
Event message Explanation
10 unsuccessful
download attempts
This is a security feature. This event occurs if someone tries to hack into the system.
Alarm An alarm has been tripped.
Alarm Restore See Alarm event message.
Autotest An autotest message was sent to the central station.
Aux Com Fail Failure to communicate with the external module, for example, the TCP/IP module.
Aux Com Fail Restore See Aux Com Fail event message.
Box Tamper A box tamper.
Burglary A burglary zone has been tripped.
Burglary Restore See Burglary event message.
Bus Fault Panel detects when bus is shorted to ground, forced to High level or there is a problem
with receiving valid bytes. About 8 seconds after this problem is detected this event will
be logged and the external bus will get disconnected for about 5 minutes. If this
situation does not disappear after 5 minutes then the external bus will be disabled for
another 5 minutes. Entering installer code will log Bus Fault Restore event and enable
the bus again.
Bus Fault Restore See Bus Fault event message.
To Next Page
Loading...
Need help?
General
