NetworX Version 3 Installation Manual
9
Preface
This is the NetworX Version 3 Installation Manual. This document includes an overview of the
product and detailed instructions explaining:
• how to install and configure the components of your NetworX V3 system; and
• how to program the system.
To use this document effectively, you should have the following minimum qualifications:
• a basic knowledge of alarm systems and components; and
• a basic knowledge of electrical wiring and low-voltage electrical connections.
Read these instructions and all ancillary documentation entirely before
installing or operating this
product.
Note: A qualified installer, complying with all applicable codes, should perform whatever hardware installation is
required.
Read “Appendix 7: EN 50131 compliance” on page 269 if you are installing a system that needs to
be EN 50131 compliant.
Safety terms and symbols
These terms may appear in this manual:
CAUTION: Cautions identify conditions or practices that may result in damage to the equipment or other property.
WARNING: Warnings identify conditions or practices that could result in equipment damage or serious personal injury.
References
For more information, refer to the following:
NetworX V3 Menu Structure
This menu structure provides a map of the NetworX V3 menu options, including those for all the
additional modules.
NX Expander Installation Guide
This manual contains detailed information about additional modules and their installation.
To Next Page
Loading...
Need help?
General
