NetworX Version 3 Installation Manual
96
3 = Zone bypass and bypass restores
4 = Zone trouble and trouble restores
5 = Power fail (AC failure), low battery, power restore (AC restore) , and low
battery bestore
6 = Bell cut, bell cut restore, telephone line restore
7 = Test reports
8 = Start and end programming, download complete and log full
Segment 2
1 = Zone and box tamper
2 = Auxiliary power over-current, and restore
3 = Wireless sensor missing and restore
4 = Wireless sensor low battery and restore
5 = Expander trouble and restore (keypads are considered as expanders)
6 = Fail to communicate
7 = Alarm restore
8 = Tamper restore
LOCATION 5 - PARTITIONS REPORTED TO PHONE N° 1 (1 segment, feature selection data)
Location 5 is used when the events to be reported to a phone number are based on the partition,
regardless of the event. If you use this location, you should program location 4 as “0”.
Segment 1
1 = Partition 1
2 = Partition 2
3 = Partition 3
4 = Partition 4
Telephone number 2
LOCATION 6 - PROGRAMMING PHONE N° 2 (20 segments, numerical data)
Phone N°2 is programmed in location 6. A “14” indicates the end of the phone number. Delays of
four seconds can be programmed at any point in the phone number by programming a “13” in the
appropriate segment. The system will always wait for a dial tone unless the first digit of the phone
number is a “13”; in this case, it will only delay. Tone (DTMF) dialling is default. If you want pulse
tone dialling, program a “15” in the segment where pulse dialling should begin. If the entire number
should be pulse dialling, program a “15” in the first segment. Program an “11” for a “*”, and a “12”
for a “#”.
Note: A zero is programmed as a “0”.
LOCATION 7 - ACCOUNT CODE FOR PHONE N° 2 (6 segments of numerical data)
Use location 7 to program the account code that is sent when phone N°2 is dialled. A zero in the
account code is programmed as a “0”. A “10” indicates the end of the account code, so program a
“10” in the segment immediately after the last digit of the account code. If the account code is 6
To Next Page
Loading...
Need help?
General
