NetworX Version 3 Installation Manual
64
2. Navigate with the ½¾ keys to Control Panel>Communications>Central Station and
press OK.
3. Scroll to Phone numbers>Phone Number 1>Dial Attempts and press OK.
4. Select 3 and press OK.
5. The keypad beeps once to confirm the change and returns to Dial Attempts.
Defining communication with a mobile phone
You can also treat a telephone (for example, your mobile phone) as a central station. This way you
can send voice messages with the NX-535 voice module (if installed) when particular events happen,
or you can send a siren tone to your mobile phone in case of an alarm.
When you do not have a PSTN analog line installed, you can easily program the panel to use a built-
in or external GSM dialer instead.
The following example configures the control panel to ring your phone using the built-in GSM dialer,
and send a siren tone to your phone in case of an alarm.
1. Navigate with the ½¾ keys to Control Panel>Communications>Central Station and
press OK.
2. Scroll to Phone numbers>Phone Number 2>Phone Number and press OK.
3. Type #0 to enter the letter "G", then type your phone number and press OK. The letter
"G" at the beginning of the phone number tells the panel to use a GSM dialer (NX-7002)
instead of a panel's analog dialer.
4. The keypad beeps once to confirm the change and returns to Phone Numbers.
5. Navigate with the ½¾ keys to Protocol and press OK.
6. Select Siren Tone and press OK.
7. Navigate with the ½¾ keys to Events and select Arm/Disarm/Alarm>Alarms, enable it
and press OK. Make sure all other options under Events are disabled.
8. The keypad beeps once to confirm the change and returns to Events.
9. Navigate with the ½¾ keys to Backup Control, enter 1, and then press OK. Entering a
"1" will cause the panel to ring your phone after executing a call to the regular central
station (Phone Number 1.)
10. The keypad beeps once to confirm the change and returns to Backup Control.
Defining communication with upload/download software
You can set up a number of conditions that must be met before a communication session is
established between the control panel and the up/download software. For more information on
programming using the upload/download software, see Chapter B10 Programming with the DL900
software.
To Next Page
Loading...
Need help?
General
