GE NetworX V3 User Manual

NetworX Version 3 Installation Manual
259
Report
Contact
ID SIA Report Contact ID SIA
Ground fault restore 310 GK Unknown Event 304 YN
Holdup Event 376 HA User Code Added 660 JY
Holdup Restore Event 376 HR User Code Change 660 UC
Keypad tamper 137 TA User Code Deleted 660 JX
Late to close 454 CI User Option Change 660 LS
Log full 605 JL Verified burglary 130 BA
Low battery 309 YT Verified burglary restore 130 BR
Low battery restore 309 YR Verified fire 110 FA
Manual fire 110 FA Verified fire restore 110 FR
Manual test 601 TX Zone Clean-me 393 YX
Off-normal AutoTest 608 RY Zone Clean-me restore 393 YZ
Opening (user number) 401 OP Zone inactive 391 NA
Opening after alarm (user
number)
406 OR Zone inactive restore 391 NS
Over-current (device
number)
312 YP Zone lost (zone number) 381 *T
Over-current restore (device
number)
312 YQ
Zone lost restore (zone
number)
381 *R
The NetworX V3 has the ability to report SIA level 1 transmissions to either or both phone numbers.
Each report in SIA consists of an Event Code and a Zone or User ID. The Zone ID will be the zone
number that is in alarm. The event code will come from the chart below, and it will be programmed
in the configuration group event code.
Table 42. Reporting zone codes - SIA
Programmed Event Code SIA Code Description
0 HA Holdup Alarm
1 FA Fire Alarm
2 PA Panic alarm
3 BA Burglary Alarm
4 BA Burglary Alarm
5 BA Burglary Alarm
6 UA Untyped Alarm
7 BA Burglary Alarm
8 BA Burglary Alarm
9 UA Untyped Alarm
10 HA Holdup Alarm
11 MA Medical Alarm
12 PA Panic alarm
13 TA Tamper Alarm
14 RP Periodic Test
15 GA Gas Alarm
16 KA Heat Alarm
17 WA Water Alarm

GE NetworX V3 Specifications

General

Brand	GE
Model	NetworX V3
Category	Security System
Language	English