GE MEDICAL SYSTEMS
D
IRECTION FK091075, REVISION 04 VIVID 3N PRO/EXPERT SERVICE MANUAL
8-136 Section 8-8 - Peripherals
8-8-4-4 Color Video Printer Installation - Procedure1 (cont’d)
Figure 8-118 Top Cover Screws
9) Place the shelf on the top surface, with its two legs facing the front, and the stoppers (located on
top of the shelf) facing the far end. Fasten the shelf to the top surface, using the screws removed
in step 8, as shown in Figure 8-119.
Figure 8-119 Shelf Fastened to Top Cover
10) Route the left end of the top surface belt through the narrow left slot in the shelf (closest to the front),
working from below the shelf, upwards.
11) Route the right end of the top surface belt through the narrow right slot in the shelf (closest to the
front), working from below the shelf, upwards.
12) Route the two sections of the additional belt (supplied with the Color Printer Shelf), through the
second pair of (outer) right and left slots, as shown in Figure 8-119, above.
13) Return the B/W printer and VCR to their original positions, between the left and right sections of the
belt.
To Next Page
Loading...
