GE MEDICAL SYSTEMS
D
IRECTION FK091075, REVISION 04 VIVID 3N PRO/EXPERT SERVICE MANUAL
Chapter 8 Replacement Procedures 8-137
8-8-4-4 Color Video Printer Installation - Procedure1 (cont’d)
14) Lock the belt buckles to tighten the shelf to the top surface. Verify that the B/W printer and VCR are
secure.
15.)Re-connect the previously-disconnected B/W Printer and VCR cables.
16) Place the Color Video Printer on top of the shelf, allowing sufficient room to access the cables at
the rear of the printer, as shown in Figure 8-120 below.
Figure 8-120 Color Video Printer and Shelf Installed on the Vivid 3N
17.)Connect the Ground cable (hanging out of the Bottom Metal Cover) to the Ground screw at the rear
of the Color Video Printer, as shown in Figure 8-121 below
Figure 8-121 Color Video Printer Ground Cable Connection
Color Video Printer
Ground Cable
Ground Screw
To Next Page
Loading...
