GE H
EALTHCARE
D
IRECTION
GA091568, R
EVISION
5 VIVID E9 S
ERVICE
M
ANUAL
8 - 72 Section 8-5 - Replacing Covers and Bumpers
8-5-17-2 Remove the Bulkhead Cover (cont’d)
8-5-17-3 Install the Bulkhead Cover
Follow these steps to install the Bulkhead Covers:
1.) Place the Bulkhead Cover’s mounting angle onto the lower edge of the bulkhead opening.
NOTE: Tuck any cables within the cover to avoid pinching the cables.
2.) Push the two upper tab locks into the openings in the Frame UI Carrier.
Figure 8-75 Bulkhead Cover removed
Figure 8-76 Install Bulkhead Cover
BULKHEAD
COVER
LOWER TAB
LOCKS
MOUNTING ANGLE
Tab locks
To Next Page
Loading...
