GE Vivid E9

GE H EALTHCARE
D IRECTION GA091568, R EVISION 5 VIVID E9 S ERVICE M ANUAL
8 - 94 Section 8-6 - Top Console Parts Replacement
8-6-5-3 Install the LCD Cables (cont’d)
4.) Feed cable through opening for second arm section.
5.) Make sure the markings line up with the midpoint placement location for the second arm
(Figure 8-104).
6.) Feed cable through opening for third arm section.
7.) For the Video and Power cables, make sure the markings appear past the third arm LCD bracket.
8.) Connect the Power Cable and the Video Cable to the LCD bracket with clips (Figure 8-105).
9.) Repeat steps for each cable replaced.
NOTE: Do not pull cables too tight. Before putting covers on arms, test arm motion and cable stress.
10.)Secure the cables in the locations indicated in Figure 8-103. Band the tie wrap through the clamp.
11.)Replace the second arm cover.
12.)Replace the third arm cover.
13.)Replace the first arm cover.
14.)Replace the bumper cover
NOTE: Rotate arm adapter assembly on arm to ensure movement is smooth and free from binding
through full 180°.
15.)Reinstall the LCD arm.
16.)Reinstall the LCD monitor.
NOTE: Rotate arm to ensure movement is smooth and free from binding through full 180°. Make sure
you do this with the arm in the proper upright position with the LCD end up.
Figure 8-104 Feed Cable through Third Arm
Figure 8-105 Clip location securing Power and Video Cables to bracket
LCD Bracket
Feed cable through
inside of third arm.
DO NOT feed cable
around outside of third
arm.
LCD Bracket