GE H
EALTHCARE
D
IRECTION
GA091568, R
EVISION
5 VIVID E9 S
ERVICE
M
ANUAL
Chapter 8 - Replacement procedures 8 - 107
8-6-8-3 Install the Frame w/LCD and Touch Screen
1.) Place the Upper Bezel, with the front down on a clean, antistatic surface.
2.) Install the Frame w/LCD and Touch Screen so it aligns with the fixing screw holes on the Upper
Bezel.
3.) Install the fixing screws.
NOTE: Be careful so you don’t bend the EMC fingers (see: Figure 8-122) when installing the LCD
Cover.
4.) Install the LCD Cover.
5.) Install the five (5x) fixing screws.
6.) Install the Operator Panel, Upper.
7.) Install the Control Knobs.
8-6-8-4 Calibration and adjustments
Run the Touch Screen Calibration in section Section 6-5 "Touch Screen Calibration" on page 6-10.
Figure 8-122 EMC fingers
Figure 8-123 Position for screws
EMC FINGERSEMC FINGERS
PROTRUDING TABS
(NOT VISIBLE IN THIS ILLUSTRATION)
To Next Page
Loading...
