GE Vivid E9

To Next Page

To Previous Page

GE H

EALTHCARE

IRECTION

GA091568, R

EVISION

5 VIVID E9 S

ERVICE

ANUAL

8 - 112 Section 8-6 - Top Console Parts Replacement

8-6-9-2 Remove the Main Controller Board (cont’d)

7.) Unscrew and remove five (5x) screws. Store them in a safe place, you will need them for the

installation.

8.) Remove the Main Controller Board.

8-6-9-3 Main Controller Board installation procedure

Follow these steps to install the Main Controller Board:

1.) Position the Main Controller Board with the USB board plugged in, so it aligns with the fixing screw

holes in the LCD frame.

2.) Install the five (5x) screws (refer to Figure 8-127).

3.) If removed, install the High Voltage Inverter board.

4.) Connect the three (3x) cables (refer to Figure 8-126).

NOTE: Take care not to damage the EMC gasketing that goes around the Touch Panel Assembly,

especially during re-assembly.

5.) Install the Back Cover.

6.) Install the Operator Panel, Upper.

7.) Install the Control Knobs.

Figure 8-127 Remove screws

Other manuals for GE Vivid E9