GE Vivid E9

GE H EALTHCARE
D IRECTION GA091568, R EVISION 5 VIVID E9 S ERVICE M ANUAL
8 - 270 Section 8-11 - Back End Processor (BEP) parts replacement
8-11-4-8-1 Cables for the Prolink Add2 card
8-11-4-8-2 Cables for the ATI FireGL V7200 card - BEP5
Figure 8-237 Cables on the Prolink Add2 card
1. I/O Unit
2. Graphics Adapter (Add2)
3. DVR Board (stipulated position to the left, installed to the right)
4. DVI Out cable
5. DVI Flex Main cable
6. SATA cable (Don’t disconnect in this procedure)
Figure 8-238 Cables on the ATI FireGL V7200 card - BEP5
1. I/O Unit
2. Graphics Adapter (ATI FireGL V7200)
3. DVR Board (stipulated position to the left, installed to the right)
4. DVI Out cable
5. DVI Flex Jumper (X cable)
6. SATA cable (Don’t disconnect in this procedure)
7. Extra Power cable for the ATI FireGL V7200 card