GE RAFT VOLUSON™ P8/VOLUSON™P6
DIRECTION 5775469, R
EVISION 3 DRAFT (JULY 19, 2018) BASIC SERVICE MANUAL
3-32 Section 3-7 - Printer Installation
3-7-3 Installing the Network Color laser Printer
1.) Power off/Shutdown the system as described in Section 3-6-3 on page 3-28
2.) Connect the printer as described in page 3-15
3.) Power On/Boot Up the system as described in Section 3-6-2 on page 3-25
4.) Press the Power On button on the printer.
5.) Install ink tanks and load paper.
6.) Wait until the printer displays Ready.
7.) By means of the Printer Controls Left<, Right> and OK set the TCP/IP address to Automatic.
8.) Press the Back button until the Printer displays Ready again.
9.) By means of the Printer Controls Left<, Right> and OK print out the Config Report.
Figure 3-20 printer controls
1. Power ON 5. Right >
2. Display 6. OK
3. Status Indicators 7. Left <
4. Cancel 8. Back
Figure 3-21 TCP/IP Config - Automatic
Figure 3-22 Reports -> Config Report
To Next Page
Loading...
