GE Voluson P6 - Section 8-37 Replacement of the CASTER; 8-37-1 Manpower; 8-37-2 Tools; 8-37-3 Preparations

GE DRAFT VOLUSON™ P8/VOLUSON™P6
DIRECTION 5775469, R
EVISION 3 DRAFT (JULY 19, 2018) BASIC SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-121
Section 8-37
Replacement of the CASTER
8-37-1 Manpower
One person, 10 minutes
8-37-2 Tools
Monkey Wrench
8-37-3 Preparations
1.) Power Off/Shutdown the system as described in 4-3-2 on page 4-4.
NOTE: Lock casters before removing them.
8-37-4 Removal Procedure
1.) Follow the removal procedure of Section 8-24 "Replacement of ASSY Bumper Base Rubber" .
2.) Unscrew the NUT. And pull out the CASTER. Refer to the figure below.
8-37-5 Installation Procedure
1.) Install the new parts in the reverse order of removal.
Figure 8-177 Unscrewing the NUT
NOTICE
Press the caster wheel locks and ensure that they keep the system from moving.