GE DRAFT VOLUSON™ P8/VOLUSON™P6
DIRECTION 5775469, R
EVISION 3 DRAFT (JULY 19, 2018) BASIC SERVICE MANUAL
Chapter 3 - Setup Instructions 3-19
3-5-5 Connecting the Wireless Network Adapter
The Wireless Network Adapter can be connected to any accessible USB port of the Voluson™ P8/
Voluson™P6.
NOTE: Connection of the WLAN Adapter is always the same.
1.) Turn ON the power of the system and wait till the system has booted.
2.) Plug the Wireless Network adapter into an accessible USB port of the Voluson™ P8/Voluson™P6.
All software drivers are pre-installed for the designated Wireless Network adapter only.
NOTE: After physical connection of the WLAN adapter to the Voluson™ P8/Voluson™P6 system, follow the
procedure described in Section 3-12-2 "Wireless Network Configuration" on page 3-73.
Figure 3-9 Connection Scheme - Wireless (USB) Network Adapter
To Next Page
Loading...
