GE RAFT VOLUSON™ P8/VOLUSON™P6
DIRECTION 5775469, R
EVISION 3 DRAFT (JULY 19, 2018) BASIC SERVICE MANUAL
3-62 Section 3-8 - System Configuration
e.) If desired, click the Save to USB button to save the USB unlock key to a connected USB
device.
f.) Click the Start encryption button.
NOTE: The process of enabling encryption of the patient data will take a consideralbe amount of time (one to
several hours).
g.) Confirm the dialogs with Yes and OK to start encryption.
A progress bar is displayed during disk encryption process.
NOTE: The system should not be used while encryption process is ongoing.
3-8-1-11-2 Unlock an encrypted Disk
If patient data stored on the internal HDDs D:\partition are encrypted (protected), following dialog
window appears as soon as the system is started.
The system has to be unlocked by one of the following possibilities:
• Enter the previously defined user Password (minimum of 8 characters) and click Unlock.
• Click the Recovery key button, enter the key into the displayed dialog and click Unlock.
• Connect the USB device with unlock key and click Unlock.
Figure 3-59 Unlock screen at encrypted disk
If the USB device with unlock key is connected to your Voluson P-series, the system is automatically
unlocked during boot up.
To Next Page
Loading...
