GE DRAFT VOLUSON™ P8/VOLUSON™P6
DIRECTION 5775469, R
EVISION 3 DRAFT (JULY 19, 2018) BASIC SERVICE MANUAL
Chapter 7 - Diagnostics/Troubleshooting 7-13
11.)Select File -> Save As, enter the file name D:\export\xxxx (xxxx= name of your preference).
If you have used a screen filter , select “Displayed”(B). This will save only rhe filltered values rather than
the entire capture.
12.)Click Save (6).
NOTE: Wireshark uses lipcap (*.pcap, *.cap) file format as the default format to save captured packets. (If you
need to open this file with D-Trace or DVTK, the capture canb eresaved in NA Sniffer Windows format).
13.)Exit the sniffer application by clicking on the [X] in the upper right corner.
14.)If you have already performed Save as, you can continue without saving and quit the program.
Figure 7-10 Save captured values
Figure 7-11 Exit Wireshark
To Next Page
Loading...
