GE DRAFT VOLUSON™ P8/VOLUSON™P6
DIRECTION 5775469, R
EVISION 3 DRAFT (JULY 19, 2018) BASIC SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-11
16.)Updating will take some time....
17.)Please wait until all processes are finished (100 percent completed).
18.)The system is rebooting into windows (Boot screen - Voluson).
NOTE: An automated process was developed to install the required software parts, perform check disk, remap
driveletters and match settings. During this process the system might reboot several times!
19.)Please wait until all processes are finished. Finally the 2D screen is displayed on the monitor.
20.)Remove the System DVD from the DVD/CD±R/RW Drive drive
NOTE: If the BT warning dialog appears, enter the proper “Permanent key” and then click SUBMIT
.
\
Figure 8-9 Please wait...
Figure 8-10 auto processes are running
To Next Page
Loading...
