If a Fetus number has been entered, several fetuses can be measured on one patient.
Select this flip switch control to change from fetus A to B or C or fetus D.
2. Make sure that the probe and application are selected properly. If another application is
selected, press the [Probe]
key on the control panel, and change it to Obstetric. For details
refer to:
Probe/Program Selection
(chapter
'Probe/Program Selection'
on page 4-7
)
11.2.4.3 Obstetric Calculations in 2D Mode
•
Distance Measurements
(chapter
'Distance Measurements'
on page 11-40
)
(like BPD,
FL, etc.)
•
Circumference Measurements
(chapter
'Circumference Measurements'
on page 11-
42
)
(like HC, AC, etc.)
•
AFI Calculation
(chapter
'AFI Calculation'
on page 11-43
)
Measurements and Patient Worksheets (Reports)
Voluson® S6/S8 Basic User Manual
5433669-100 Revision 4 11-39
To Next Page
Loading...
