Chapter 2, Cutter Controls 19
In online mode you can:
Set a new origin
Initiate a sheet-off action
Browse through the parameter settings without changing them
In offline mode, you are in control of the cutter and can alter the cutter
settings such as
Tool Force Speed
Accelerations Page Length Origin
Slew keys
TEST
OFFSET
SETUP
SETTINGS
With the slew keys, you can move the tool head and the material so you
can examine specific details of the job or set a new origin (start point). The
slew keys are always active, whether the cutter is online or offline.
When you press the
½
(left) or
¾
(right) slew key, the tool head moves in
the Y-axis, slowly for 2 seconds and then speeds up.
When you press the
¿
(up) or
À
(down) slew key, the material (if loaded)
moves in the X-axis, slowly for 2 seconds and then speeds up.
ORIGIN key
The ORIGIN key allows you to register a new origin (start) point if material
has been loaded. A new origin point can be set in offline as well as in
online mode.
To register a new start point
1. Using the slew keys, place the tool head at the desired origin point.
2. Press the ORIGIN key. LEDs on the LED bar will flash to confirm your
action.
If the tool head Is located beyond the borders of the material, the new origin
point will be rejected.
To Next Page
Loading...
Need help?
General
