Gerber Fastrack - Chapter 1: Installation Procedures; Preparing the Cutter Environment

4 Chapter 1, Installation
CHAPTER 1
INSTALLATION PROCEDURES
PREPARING THE CUTTER ENVIRONMENT
The location where you set up your equipment is very important. Please
ensure that it meets the following conditions:

Power supply of 100 to 120 VAC 50/60 Hz or 200 to 240 VAC 50/60
Hz.

Ambient Conditions
•
Operating environment
- Temperature: 41°F to 104°F (5°C to 40°C)
- Humidity: 35% - 75% non-condensing
•
Recommended environment
- Temperature: Room temperature 61°F to 90°F (16°C to 32°C)
- Humidity: 50% to 65%, non-condensing
•
Variation rate
- Temperature: 3.6°F (2°C) per hour
- Humidity: 5% per hour
•
Storage environment
- Temperature: 32°F to 122°F (0°C to 50°C)

Protect your cutter from moisture, dust, drafts, and direct sunlight. It is
best to keep your machine away from air-conditioners and open
windows.

Ensure that there is an adequate space around the cutter to ensure
proper ventilation.

Avoid unnecessary vibrations and set up your cutter on a level surface.

When selecting a place for your cutter, leave at least 35.5" (900 mm) in
front and 35.5" (900 mm) at the rear, as shown in the illustration on the
next page.