Gerber Fastrack User Manual

Chapter 3, Cutter Settings and Special Functions 41
To change the serial communication settings
In line 8, choose one of the preinstalled sets or the User Defined selection.
If you need to use the User Defined option, alter the settings one by one
until they match the desired values.
6. Using the
½
and
¾
(left and right) slew keys, position the tool head
above the desired selection (between 8 and 16) in the menu selection
line.
7. Press ENTER to confirm this choice.
The cutter plots the corresponding line and the tool head parks above
the current setting. The factory default setting is default 2.
8. To keep the current setting, use the
¿
and
À
(up and down) slew keys
to return to the menu selection line leaving the original setting
unchanged.
9. To change the setting, use the
½
and
¾
(left and right slew) keys to
position the tool head above the desired setting.
10. Press the ENTER key to save the new setting into memory.
At the same time, the new selection is underlined and the tool head
returns to the menu selection line, allowing a new selection.

Gerber Fastrack Specifications

General

Brand	Gerber
Model	Fastrack
Category	Cutter
Language	English