68 Chapter 5, Cutter Maintenance and Troubleshooting
Recoverable system errors
Use the Error Code chart below to determine the error code being
displayed by the LED bar. Then use the chart at the bottom of the page
to determine the possible cause and corrective action.
ERROR CODE
10% 20% 30% 40% 50% 60% 70% 80% 90% 100%
IMPOSSIBLE AUTO-
ONLINE RECOG. (S02)
G. LANGUAGE NOT
CORRESPONDING (S03)
MATERIAL DETECT
ERROR (S05)
ROLL MATERIAL END
(S06)
CANNOT AUTO-CONNECT
(S07)
AUTO CUT ERROR
(S08)
CHANGE MATERIAL
(S28)
KANJI ROM SUM ERROR
(S29)
POSSIBLE CAUSE and SUGGESTED ACTION
S02 Communication difficulties - Check cables.
S03
Select other graphics language. (See
Language Settings
page 42, in Chapter 3.)
S05 Material detection impossible.
Too much or too little light, incorrect pressure roller position.
S06 Load a new sheet or roll.
S07 Communication difficulties - Check cables.
S08 Error during auto-sheet-off sequence.
Check material and auto-cut knife
S28 Change or reload material.
To Next Page
Loading...
Need help?
General
