Gerber Fastrack User Manual

30 Chapter 2, Cutter Controls
AVAILABLE VALUES/SETTINGS FOR PARAMETERS - IMPERIAL
SYSTEM
All speeds are given in inches per second.
SPEED
10% 20% 30% 40% 50% 60% 70% 80% 90% 100%
TOOL 1
4 8 12 16 20 24 28 32 36 40
TOOL 2
4 8 12 16 20 24 28 32 36 40
TOOL 3
24 6 81012 14 16 18 20
TOOL 4
4 8 12 16 20 24 28 32 36 40
Tool-Up
4 8 12 16 20 24 28 32 36 40
All accelerations are given in G (m/s²).
ACCEL.
10% 20% 30% 40% 50% 60% 70% 80% 90% 100%
TOOL 1
0.5 1 1.5 2 2.5 3.0 3.5 4 - -
TOOL 2
0.5 1 1.5 2 2.5 3.0 3.5 4 - -
TOOL 3
0.5 1 1.5 2 2.5 3.0 3.5 4 - -
TOOL 4
0.5 1 1.5 2 2.5 3.0 3.5 4 - -
Tool-Up
0.5 1 1.5 2 2.5 3.0 3.5 4 - -
All forces are given in grams (1 g = 0.01 Newton)
FORCE
10% 20% 30% 40% 50% 60% 70% 80% 90% 100%
Range 1
15 20 30 40 50 60 70 80 90 100
Range 2
110 120 130 140 150 160 170 180 190
N/A
Range 3
200 200 200 200 250 300 350 400 450 500
Defaults: TOOL 1 (Knife1) (100 g) TOOL 2 (Knife2) (100 g)
TOOL 3 (Pen1) (20 g) TOOL 4 (Pen2) (80 g) Sheet-Off (300 g)
All distances are given in inches
SHUFFLE
10% 20% 30% 40% 50% 60% 70% 80% 90% 100%
Length
0162432
40 80 120 160 200 400
Factory Default Settings: TOOL 1 = Knife 1 TOOL 2 = Knife 2
TOOL 3 = Pen 1 TOOL 4 = Pen 2
= Factory default

Gerber Fastrack Specifications

General

Brand	Gerber
Model	Fastrack
Category	Cutter
Language	English