Chapter 5, Cutter Maintenance and Troubleshooting 65
ERROR MESSAGES
Unrecoverable system errors
Unrecoverable errors may be caused by some part of the cutter that is
malfunctioning. In case of an unrecoverable error, most of the time the
cutter will be completely blocked and all the LEDs will be flashing. Press
ENTER to display an error code on the LED bar.
To return your cutter to normal operation, switch it off and then on. If you
still get the same error message, please contact your Gerber distributor
and be prepared to give the following information: serial number, type,
error message displayed, and a description of the malfunction.
ERROR CODE
10% 20% 30% 40% 50% 60% 70% 80% 90% 100%
ERROR CODE 0
WATCH DOG TIME OUT
BUS TRAP ERROR
ADDRESS TRAP ERROR
ILLEGAL
INSTRUCTION(MC68020)
ZERO DIVIDE
GENERAL PROCESSOR
FAILURE
EPROM CHECKSUM ERROR
KANJI ROM CHECKSUM
ERROR
SRAM FAILED I/O TEST
DRAM FAILED I/O TEST
INTERRUPT FAILURE
X IS OUT OF SYNC
Y IS OUT OF SYNC
INPOSITION TIME OUT FOR
X
INPOSITION TIME OUT FOR
Y
OVER CURRENT X
OVER CURRENT Y
X ENCODER FAILED
X ENCODER FAILED
To Next Page
Loading...
