Gerber Fastrack User Manual

Chapter 2, Cutter Controls 31
AVAILABLE VALUES/SETTINGS FOR PARAMETERS, METRIC
SYSTEM
All speeds are given in centimeters per second.
SPEED
10% 20% 30% 40% 50% 60% 70% 80% 90% 100%
TOOL 1
10 20 30 40 50 60 70 80 90 100
TOOL 2
10 20 30 40 50 60 70 80 90 100
TOOL 3
51015202530 35 40 45 50
TOOL 4
10 20 30 40 50 60 70 80 90 100
Tool-Up
10 20 30 40 50 60 70 80 90 100
All accelerations are given in G (m/s²).
ACCEL.
10% 20% 30% 40% 50% 60% 70% 80% 90% 100%
TOOL 1
0.5 1 1.5 2 2.5 3.0 3.5 4 - -
TOOL 2
0.5 1 1.5 2 2.5 3.0 3.5 4 - -
TOOL 3
0.5 1 1.5 2 2.5 3.0 3.5 4 - -
TOOL 4
0.5 1 1.5 2 2.5 3.0 3.5 4 - -
Tool-Up
0.5 1 1.5 2 2.5 3.0 3.5 4 - -
All forces are given in grams (1 g = 0.01 Newton)
FORCE
10% 20% 30% 40% 50% 60% 70% 80% 90% 100%
Range 1
15 20 30 40 50 60 70 80 90 100
Range 2
110 120 130 140 150 160 170 180 190 N/A
Range 3
200 200 200 200 250 300 350 400 450 500
Defaults: TOOL 1 (Knife1) (100 g) TOOL 2 (Knife2) (100 g )
TOOL 3 (Pen1) (20 g) TOOL 4 (Pen2) (80 g) Sheet-Off (300 g)
All distances are given in centimeters
SHUFFLE
10% 20% 30% 40% 50% 60% 70% 80% 90% 100%
Length
0406080100 200 300 400 500 1000
Factory Default Settings: TOOL 1 = Knife 1 TOOL 2 = Knife 2,
TOOL 3 = Pen 1 TOOL 4 = Pen 2
= Factory default

Gerber Fastrack Specifications

General

Brand	Gerber
Model	Fastrack
Category	Cutter
Language	English