Gerber Fastrack User Manual

Chapter 3, Cutter Settings and Special Functions 37
A
: Original origin.
B
: End point last vector
C
: New origin with
Page Mode 1
D
: New origin with
Page Mode 2
To set the SHEET-OFF / PAGE MODE
1. Using the
½
and
¾
(left and right slew) keys, position the pen above
selection 5 in the menu selection line.
2. Press ENTER to confirm this choice.
The cutter will plot the following line:
5 SheetOff / PGmode: PM0 PM1 PM2
after which the tool head will park above the current setting. The
factory default is Page Mode 2.
3. To keep the current setting, use the
¿
and
À
(up and down) slew keys
to return to the menu selection line leaving the original setting
unchanged.
4. To change the setting, use the
½
and
¾
(left and right slew) keys to
position the tool head above the desired setting.
5. Press the ENTER key to save the new setting into memory.
At the same time, the new selection is underlined and the tool head
returns to the menu selection line, allowing a new selection.

Gerber Fastrack Specifications

General

Brand	Gerber
Model	Fastrack
Category	Cutter
Language	English