Chapter 5, Cutter Maintenance and Troubleshooting 59
2. Cut a strip of vinyl 0.3" (8 mm) wide and its length depending on the
size of your cutter. Stick this strip into the cutting groove.
3. Complete this procedure by sticking the new cutting mat into the
cutting groove.
To replace the knife blade
in the standard knife holder
1. Hold the body (2) in one hand and unscrew the base (1).
2. Remove the spring (3) and the cutting blade (4).
3. Slide the spring over the new cutting blade.
4. Place the new blade with its spring into the base and screw the whole
assembly onto the body.
To Next Page
Loading...
Need help?
General
