Chapter 5, Cutter Maintenance and Troubleshooting 69
Communication errors
Communication errors are caused by a problem in the communication
between the cutter and the host computer. They can be caused by errors
related to the communication settings, errors due to a defective
handshake, or command format errors in the ESCAPE sequences.
Use the Error Code chart below to determine the error code being
displayed by the LED bar. Then use the chart on the next page to
determine the possible cause and corrective action.
ERROR CODE
10% 20% 30% 40% 50% 60% 70% 80% 90% 100%
ERROR ONLINE FRAME
C01
ERROR ONLINE OVERRUN
C02
ERROR ONLINE PARITY
C03
ERROR BIAS VALUE
C04
ERROR SUM CHECK
C05
ERROR DATA BLOCK
C06
FEW PARAMETER ESC
C07
FEW PARAMETER ESC
C08
COMMUNICATION BUSY
C09
UNDEFINED ESC
C10
ILLEGAL ESC
C11
ERROR VALUE ESC
C12
MANY PARAMETERS ESC
C13
COMMUNICATION ERROR
C14
BUFFER OVERFLOW
C15
To Next Page
Loading...
Need help?
General
