70 Chapter 5, Cutter Maintenance and Troubleshooting
POSSIBLE CAUSE and SUGGESTED ACTION
C01 Framing error.
C02 Overrun error.
C03 Parity error.
C04 Bias is less than EOB code.
C05 Check-sum difference cutter vs. host.
C06 Data between bias and EOB too large.
C07 Not enough ESC-parameters.
C08 Not enough ESC-parameters.
Check the
Communication Settings,
page
40, in Chapter 3.
C09 Change the computer program to prevent
the cutter from returning double data.
C10 Undefined ESCAPE sequence.
C11 Illegal character used for MH-GL/2 ESC-
sequence.
C12 Illegal character in ESC-sequence
parameter.
C13 Too many ESC-sequence parameters.
Check the ESCAPE command setup.
C14 Communication error.
C15 Buffer overflow.
Restart the cutter.
To Next Page
Loading...
Need help?
General
