Gerber Fastrack - Chapter 7: Material Compatibility and Dimensions; Material Compatibility Guide

66 Chapter 5, Cutter Maintenance and Troubleshooting
ERROR CODE
10% 20% 30% 40% 50% 60% 70% 80% 90% 100%
POSITION TIME OUT
MOVING COIL

POSITION TIME OUT PEN
MOTOR
 
OVER CURRENT MOVING
COIL
 
OVER CURRENT PEN
MOTOR

OVER FORCE MOVING COIL

OVER FORCE PEN MOTOR

MOVING COIL A/D FAILURE
 
PEN MOTOR A/D FAILURE

CURRENT TIME OUT
MOVING COIL
 
CURRENT TIME OUT PEN
MOTOR

POWER FAILURE

DRIVER IS OVER HEATED

FAN FAILURE

MATERIAL BROKEN

Y ORIGIN NOT FOUND
 
REFILL TANK FAILED

LOST HEAD
 
1010 CPU ERROR
 
1111 CPU ERROR
 
PEN CHANGE ERROR

EEPROM ERROR

CUTTER ERROR

EXTENDED RAM ERROR
  
Y EDGE ERROR
 
MATERIAL HANGER ERROR

X OVER LOAD ERROR
 
Y OVER LOAD ERROR
 
UNKNOWN ERROR

UNKNOWN ERROR
