64 Chapter 5, Cutter Maintenance and Troubleshooting
15. Save this file onto a floppy diskette or your hard-drive.
16. Exit the text editor and return to the MS-DOS prompt.
17. Make sure you are in the directory where the file is located.
18. Type following command:
copy TEST.PLT COM1 (If your cutter is connected to COM1)
copy TEST.PLT COM2 (If your cutter is connected to COM2)
19. Press ENTER.
The file you have created will now be sent to the cutter, causing it to
cut/draw a square 3.94” by 3.94” (10 cm by 10 cm) and a circle with a
radius of 1.97” (5 cm).
To Next Page
Loading...