3.2.3.3.2.7 Test triac
This menu is used for testing and controlling the triac by adjusting
its value in percent.
Note: If there is no value, the function is not used.
Set the manual mode to edit a value and test the triac.
• To switch between manual and automatic mode, selection the
Alternative key for the desired triac and press to change
mode.
•
To edit the value, select the value field and press . A
window is displayed with an editable field for the value. Edit
by using the cursor keys. Press to save the low value. The
previous window is displayed again.
• Select
at the bottom of the list and press to save the
settings.
3 MENU TREE
36 (128) TECHNICAL MANUAL GETINGE WD15 CLARO
<Doc_TEC><Doc_6001396902><Rev.I><Lang_en>
To Next Page
Loading...
Need help?
General
