Important:
• If you change the breathing circuit after
completion of the Pre-use check, perform
a new Pre-use check or a patient circuit
test.
• When the Pre-use check is completed,
all possible sources of alarm signals have
been verified and the alarm system
operates correctly.
6.2.1 Start-up
1. Connect power and gas supplies:
Power: AC outlet•
• Gas: Air and O
2
CAUTION: Ensure that the cable to the User
Interface is never disconnected while the
SERVO-s Ventilator System is powered on.
2. Turn the ventilator on.
SERVO-s VENTILATOR SYSTEM V8.0, User's Manual
105
| Operation overview |
6 |
To Next Page
Loading...
Need help?
General
