5.3.11 Previous mode
SVS-6072_XX
1. Time when previous mode was
inactivated.
2. Press the touchpad Show previous mode
to recall the previous accepted ventilation
mode.
SVS-6071_XX
3. Activate the previous used ventilation
mode settings by pressing the Accept
touchpad.
Notes:
• The previous mode function is not
available after a Pre-use check, changing
of patient category, admitting a new
patient, use of the same ventilation mode
for more than 24 hours or after start-up
(cold start) of the system.
• When "Previous Mode" is activated
during Backup ventilation, the ventilator
returns to the mode that was active
before Support mode was initiated.
• A recall of previous settings is only
possible after a change of ventilation
mode.
SERVO-s VENTILATOR SYSTEM V8.0, User's Manual
61
| Ventilation, modes and functions |
5 |
To Next Page
Loading...
