6.6 Set ventilation mode
To set ventilation mode and parameters:
1. Press the Mode touchpad.
2. Press the arrow at the active Mode
touchpad.
Available ventilation modes appear.
3. Press the touchpad for desired mode of
ventilation.
Note: If the type of ventilation is set to
NIV(option), the only available modes
are NIV Pressure Support and NIV
Pressure Control.
4. When a ventilation mode has been
selected, all related parameters can be
set in the same window. Calculations are
also displayed in this window.
5. Values are adjusted by turning the Main
Rotary Dial.
6. Confirm each setting by pressing the
parameter touchpad or pressing the Main
Rotary Dial.
7. To activate all settings in the window
press Accept, or to cancel the settings
press Cancel.
Procedure Diagram: Set Ventilation Mode
SVS-6032_XX
114
SERVO-s VENTILATOR SYSTEM V8.0, User's Manual
| 6
| Operation overview |
To Next Page
Loading...
Need help?
General
