Getinge Maquet SERVO-s - Optional Accessories for SERVO-s

To Next Page

To Previous Page

8 Optional Accessories

Table of contents

130|General8.1

130|Active humidifiers8.2

131|Nebulizers8.3

132|Compressor Mini8.4

SERVO-s VENTILATOR SYSTEM V8.0, User's Manual

129

| Optional Accessories |

8 |

Main Page

Table of Contents3
Introduction5
Device Description6
Device Diagram6
Intended Use6
Intended User6
Servicing Guidelines7
Disclaimers7
Improper Use Environment7
Nonprofessional Servicing7
General8
Warning, Caution and Note8
Power Supply11
Fire Hazard11
Maximum Levels12
Gases12
Auxiliary Equipment12
Electromagnetic Compatibility13
Version and Configurations14
Patient Range (Kg)14
Configurations14
System Overview15
Ventilator16
System Overview Diagram17
System Components17
User Interface - Connections, Labels and Symbols18
User Interface Diagram18
User Interface Components19
User Interface Symbols20
Navigating the User Interface21
Touch Screen21
To Adjust Ventilator Settings21
Main Rotary Dial22
Fixed Keys23
Direct Access Knobs24
Using Direct Access Knobs24
Direct Access Knobs - Safety25
Menu Key26
To Access the User Interface Windows26
Status Touchpad27
Patient Unit - Connections, Labels and Symbols28
Patient Unit Diagram28
Connections and Labels29
Patient Unit Components29
Patient Unit Symbols30
Patient Unit Gas Flow Diagram32
Gas Flow through the Patient Unit33
Symbols on Accessories and Packaging34
Transport and Storage35
Before Intrahospital Transport35
During Intrahospital Transport35
Viewing Battery Status38
Alarms and Safety40
Status Messages41
AC Power Failure41
Table of Contents43
Monitor and Record43
To View more Values44
Display Additional Pages44
Measured Values Display44
- Values List45
- Show and Hide46
- To Show or Hide the Volume Waveform46
Waveform Display46
Adjust Scale/Sweep Speed47
Show Event Log48
Show Loops48
Show Trends49
- Ventilation, Modes and Functions51
- Warnings52
- Application53
- Scope - Ventilatory Needs53
- Flow-Time Waveform54
- Important Definitions54
- Pressure-Time Waveform54
- Volume Control54
- Pressure Control55
- Volume-Time Waveform55
- Settings56
- Trigger Functionality56
- Inspiratory Rise Time57
- I:E Ratio / Inspiration Time58
- Peep58
- End Inspiration59
- Breath Cycle Time60
- Respiratory Rate / SIMV Rate60
- Volume Setting60
- Previous Mode61
- Flow Adaptation62
- Functional Description Volume Control62
- Expiration Starts64
- Volume Control in Detail64
- Volume Control with Alternative Flow Patterns65
- Volume Control with Decelerating Flow65
- Volume Control with Flow Adaptation65
- Volume Control Without Flow Adaptation65
- Functional Description Pressure Control67
- Pressure Control in Detail68
- Active Expiratory Valve69
- Functional Description PRVC70
- Pressure Regulated Volume Control70
- PRVC in Detail71
- Functional Description Pressure Support73
- Pressure Support73
- Pressure Support in Detail75
- Functional Description Spontaneous Breathing/Cpap76
- Spontaneous/Cpap76
- Spontaneous Breathing/Cpap in Detail77
- Functional Description SIMV78
- Simv78
- The Mandatory Breath79
- SIMV (Volume Control) + Pressure Support80
- SIMV - in Detail81
- SIMV (VC) + PS with Alternative Flow Patterns82
- SIMV (Pressure Control) + Pressure Support83
- SIMV (PRVC) + Pressure Support85
- Bi-Vent/Aprv87
- Bi-Vent in Detail89
- Non Invasive Ventilation90
- Differences from Invasive Pressure Control Mode92
- Backup Ventilation94
- No Patient Effort94
- Continue in Support Mode95
- No Consistent Patient Effort95
- Review Ventilation Settings95
- Disabling Backup Ventilation96
- To Disable Backup Ventilation96
- Ventilatory Parameters - Overview97
- Special Functions100
- Start Breath100
- Expiratory Hold101
- Inspiratory Hold101
- Operation Overview103
- Pre-Use Check104
- Workflow Summary104
- Start-Up105
- Battery Switch Test106
- Internal Leakage Test106
- Patient Circuit Test107
- Compensate for Circuit Compliance108
- Test Alarm Output Connection108
- Complete the Pre-Use Check109
- Pre-Use Check Tests110
- Enter the Patient Data112
- Procedure Diagram: Enter Patient Data113
- Procedure Diagram: Set Ventilation Mode114
- Set Ventilation Mode114
- To Set Ventilation Mode and Parameters114
- Set Alarm Limits115
- To Set Alarm Limits115
- Start Invasive Ventilation116
- Start Non Invasive Ventilation (NIV)116
- Start Ventilation116
- Additional Settings Window117
- Pre-Oxygenation/Preparation Phase118
- Suction Support118
- Suctioning118
- Closed-Suction Systems119
- Disconnect Phase119
- Post-Oxygenation Phase119
- Disconnect the Patient120
- Re-Adjust the Oxygen Cell120
- To Disconnect and Stop Ventilation120
- Alarms121
- Alarm Output Connection Option123
- Visual Alarm Display123
- Handling Alarms124
- Viewing the Current Alarms Window124
- Responding to Alarms125
- To Respond to a High or Medium Priority Alarm125
- To Respond to a Low Priority Alarm125
- Using the Audio Pause Key125
- Pre-Silencing Alarms126
- Permanently Silencing Alarms127
- Resetting Latched Alarms127
- Responding to Technical Alarms127
- Alarm Settings for Breathing128
- List of Alarm Settings128
- Setting Alarm Limits128
- Viewing Alarm Limits128
- Optional Accessories129
- Active Humidifiers130
- General130
- Aerogen Nebulizer System131
- Nebulizers131
- Compressor Mini132
- System Messages133
- Introduction134
- High Priority Alarms135
- Medium Priority Alarms138
- Low Priority Alarms140
- Technical Error Messages140
- Start-Up Configuration141
- Access the Start-Up Configuration142
- Introduction142
- Edit the Start-Up Configuration143
  - Procedure Diagram143
  - To Edit the Start-Up Configuration143
- Start Mcare Remote Service144
- Technical Data145
- Standards146
- Electromagnetic Compatibility (EMC)146
- Mechanical Strength146
- Battery Lifetime147
- Battery Backup147
- Max Power Consumption147
- Power Supply, Automatic Range Selection147
- Dimensions (MM)148
- Unavailable Gas/Loss of Gas Pressure148
- Conical Fittings (MM)148
- Gas Exhaust Port (MM)148
- Standard Condition Specification149
- Patient Circuit150
- Inspiratory Channel150
- Expiratory Channel151
- Monitoring151
- Inspiratory Tidal Volume151
- Expiratory Minute Volume151
- Filtering152
- Supply Pressure152
- Airway Pressure152
- Breathing Parameters: Default Values & Allowed Settings153
- Alarm Limits155
- High Airway Pressure156
- Audio Pause (Alarm Silence/Reset)156
- Alarm Sound Level156
- Maximum Inspiration Time156
- Trend Function157
- Log Function158
- Communication Interface Emulator (CIE)158
- Alarm Output Connection (Option)158
- Service Log158
- Servo Duo Guard159
- Weight (Kg)159
- Accessories159
- Expiratory Heater, Servo Duo Guard160
- Servo Guard160
- Pollution Control161
- Hazardous Substances161
- Maximum Inaccuracy of PEEP162
- Pressure-Controlled Breath Type162
- Volume-Controlled Breath Type162
- UDI Label163
- Definitions165
- User Interface167
- Quick Access Key170
- Main Screen Key171
- Biomed Menu (Standby Mode)174
- Screen Touchpads176
- Index179

Getinge Maquet SERVO-s - Optional Accessories for SERVO-s

Table of Contents

Related product manuals