GWN76XX User Manual
Version 1.0.19.25
2G in Priority: 2G Band will be prioritized over 5G Band
5G in Priority: 5G Band will be prioritized over 2G Band
Balance: GWN will balance between the clients connected to 2G and those
connected to 5G.
You can configure Trunk port or Access port. When it’s set to Access, you also need
to specify the VLAN ID.
For example, if you have multiple SSIDs on different VLANs, then the port need to
be set to Trunk in order to negotiate trunk with the switch port where the AP is
plugged. Otherwise if there is only one SSID/VLAN the port type is set to Access.
This feature is not supported in GWN7600/7600LR/GWN7610.
Set the Radio Power depending on desired cell size to be broadcasted, four options
are available: “Low”, “Medium”, “High” and “custom” Default is “High”.
Custom
2.4GHz/GHz Tx
Power (dBm)
Allows users to set a custom wireless power for both 5GHz/2.4GHz band, the value
of this field must be between 1 and 31.
Configures whether to enable/disable Minimum RSSI function. This option can be
either Disabled, or Enabled and set manually or set to Use Radio Settings.
Minimum
Access Rate
Limit
Specify whether to limit the minimum access rate for clients. This function may
guarantee the connection quality between clients and AP. This option can be either
Disabled, or Enabled and set manually or set to Use Radio Settings.
Notes:
The administrator can filter access points by Model or search by name/MAC of the device.
Click on Button to save the changes and apply them to the AP.
Reset Access Points
To reset an access point, select and click on button, a confirmation message will be
displayed, click on to confirm the operation.
To Next Page
Loading...
Need help?
General
